Requires a MagTest Software version 1.4.3 or higher. Testing up to 200 kHz is done with Multimeters. Testing 200 kHz to 1 MHz is done with R&S RTE Oscilloscope. Oscilloscope should be kept at least 1m away from LFPA as GPIB communication may get influenced. Therefore one longer GPIB cable is offered.
The Schwarzbeck´s Mess-Elektronik MagTest software can be used to perform magnetic field immunity tests according to several standards, such as, for example: MIL-STD-461G, ISO 11452-8, DIN EN 61000-4-8 and many others. The MagTest software can control the hardware to produce…
The primary function of the compensation network NFCN 9734 is to provide a serial compensation of the inductance of Helmholtz coils (e.g. the HHS 5206-16). Thus the currents needed to produce the desired field strength can be achieved using relatively…
The SW 9605 Current Clamp was designed to measure RF-currents on conductors or conductor bundles with a maximum diameter of 23 mm. The conversion ratio is 1:1 in the nominal frequency range, therefore the receiver-reading in dBµV corresponds directly to the current in dBµA.
The LFPA 9733 C is a multi-purpose power amplifier and can be used within the frequency range from 5 Hz to 1 MHz. Typical applications are magnetic immunity testing according to automotive standards and MIL-461. Its new output stage design…
The HFRAE 5163 loop antenna for magnetic fields is designed to measure medium to high-level field strengths in the frequency range from 9 kHz to 400 MHz in combination with 50 Ω measuring instruments. The loop is shielded against electrical…
The current sensor CP 9610 can measure up to 40 A in a frequency range from DC – 1 MHz. It is galvanically isolated and can withstand a maximum voltage of 210 VPK / VDC. The internal resistance of the…
The magnetic, handheld field sensor coil FESP 5134-40 was designed to determine the magnetic fieldstrength during immunity tests in conjunction with an appropriate voltmeter. The main application is in the audio frequency range and above up to approx. 250 kHz…
The magnetic field monitoring loop FESP 5133-7/41 was designed to measure magnetic fields in the frequency range up to 200 kHz. The coil is made of 36 turns AWG 7/41 RF-litz wire. The turns are shielded to suppress eventually disturbing…
The magnetic, handheld coil FESP 5133 was designed to generate defined magnetic field strength in the audio frequency range up to 3 MHz. The main application is immunity testing against magnetic fields according to VG 95377 Part 13 and many…
The magnetic, handheld coil FESP 5132 was designed to generate defined magnetic fieldstrength in the audio frequency range up to 100 kHz. The main application is immunity testing against magnetic fields according to EN 55103 and MIL-STD-461 G. Depending on…