SPLIT 100 is a resistive, symmetrical two port splitter with an impedance of 100 Ω.
It is part of the measurement setup according to EN 50561-1:2012.
This splitter is built in a resistive way. Resistors made with tight tolerances and temperature stable have been used. Thus the device can be used for a wide frequency range.
The SPLIT 100 has a very flat frequency response of typically less than 0.2 dB and can be used up to above 50 MHz. The input and output connectors are symmetrical to earth and show identical properties in each of the three directions.
| Frequency range: | DC … 30 MHz |
| Usable frequency range: | DC … >50 MHz |
| Insertion loss: | 6 dB ± 0.2 dB |
| Frequency response: | > +/-0.5 dB |
| Nominal Impedance: | 100 Ω |
| Max. Input power: | 1 W |
| Proof voltage against housing: | >500 VDC |
| Terminals: | 4 mm safety laboratory jack |
| Length: | 125 mm |
| Width: | 104 mm |
| Hight: | 50 mm |
| Weight: | ca. 270 g |
Datenblatt SPLIT 100
Overview PLC Measurement-System EN 50561-1