The AC separators provide connectivity between the LISNs and the device under test (DuT) respectively the auxiliary equipment (AE) as well as the connection to the measurement setup.
Two of the R/C elements required by the standard EN 50561-1 are already built in (1 M || 100 nF). Two identical AC separators are required for the measurement setup.
Two of the R/C elements required by the standard EN 50561-1 are already built in (1 M || 100 nF). Two identical AC separators are required for the measurement setup.
| Frequency range: | 1.6 MHz … 30 MHz |
| Symmetrical attenuation:(@ 100 Ω) | max. 0.5 dB |
| Max RF voltage: | 10 V |
| Dieelctric strength each wire: | >1000 VDC |
| Test voltage between lines: | >1000 VDC |
| Max. power rating: | 1000 VA |
| Connector Mains plug: | CEE 7/7 |
| Connector Mains jack: | CEE 7/4 |
| Connections to the test circuit: | 4 mm safety laboratory jack |
| Housing dimensions: | |
| Length: | 68 mm |
| Width: | 112 mm |
| Hight: | 53 mm |
| Weight: | 310 g |
Datasheet AC – Separator
Overview PLC Measurement-System EN 50561-1