VAMP 9243 – Vertical Active Monopole Antenna

This product has been discontinued. It can be replaced by: VAMP 9243 B – Vertical Active Monopole Antenna

Datasheet VAMP 9243
Schwarzbeck VAMP 9243 - Low Noise Active Vertical Monopole Antenna
Schwarzbeck VAMP 9243 – Low Noise Active Vertical Monopole Antenna

Option GP: Aluminium-Groundplane, 0.6 x 0.6 m
Option GP: Aluminium-Groundplane, 0.6 x 0.6 m
Schwarzbeck Option MIL461 bonding kit for VAMP 9243
Option MIL461: bonding kit for VAMP 9243

Opt. VT: 20 dB plug in divider to measure high field strength
Option VT: 20 dB plug in divider to measure high field strength
Low noise active monopole antenna VAMP 9243 consists of a vertical rod and an impedance matching amplifier. The rod has a standard length of 1m (other rod length on request) and can be considered as short compared to the wave length in the frequency range 9 kHz – 30 MHz.

The conversion factor is independent of the frequency because of the extremely high impedance of the matching amplifier. The circuit gives best results of noise and intermodulation for a conversion factor (antenna factor) of +10 dB and sensitive measuring receivers are able to use the whole dynamic range of the antenna.

With mounting nut for AM 9144 and rechargeable battery.

Frequency Range:9 kHz – 30 MHz
Polarisation:linear
Pattern Type:omnidirektional
Connector:BNC-female
Impedance:50 Ohm nominell
Amplifier Dimensions:
Length:180 mm
Width:80 mm
Hight:40 mm
Rod Length:1 m
Weight:900 g
Mounting:1/4″, 3/8″

Datasheet VAMP 9243

Options:

  • Opt. GP: Aluminium-Groundplane, 0.6 x 0.6 m
  • Opt. VT: 20 dB plug in divider to measure high field strength
  • Opt. CA 9243: Calibration Adapter for VAMP 9243
    Opt. CA 9243
  • Opt. MIL461F bonding kit: Bonding kit for VAMP 9243 acc. MIL-STD-461F consisting of a BNC cable double shielded ca. 70 cm, with braid current blocking ferrite in the center, elbow aluminium angle with BNC bulkhead adapter.
    Opt. MIL 461F Bonding Kit
  • Opt. ACS 410: Charger ACS 410