For calibrations of current transformers there is additional equipment required, a coaxial termination resistor and e.g. a network analyser, a spectrum analyser with tracking generator or a signal generator with a receiver.
The calibration fixture comes with two N-female connectors, each of them is equipped with a high quality 4 mm banana plug to accept the inner conductor of the fixture. The CA 9608 comes with knurled-head screws at both sides, which allows a fast opening without any tools. This is especially useful for “push-through” current transformers, which can not be clamped or opened. The height of the inner conductor is variable, this provides a wide range of possible current transformer sizes up to 86 mm diameter to be calibrated with a single adapter. A longer inner conductor is available on request in order to calibrate current transformers of up to 90 mm width.
| Frequency Range: | DC-500 MHz |
| Connector: | 2 x N female |
| Material: | Aluminium |
| Weight: | 480 g |
| Dimensions: | 180 x 85 x 55 mm |
| Height Inner Conductor: | 25 … 43 mm |
| Diameter Inner Conductor: | 12 mm |
| Suitable for: | SW 9605, SW 9606, R&S EZ-17, ESV-Z1, FCC, Prodyn IT-050-1, etc. |
