The SW 9605 Current Clamp was designed to measure RF-currents on conductors or conductor bundles with a maximum diameter of 23 mm. The conversion ratio is 1:1 in the nominal frequency range, therefore the receiver-reading in dBµV corresponds directly to the current in dBµA.
SW 9602 Current Transformer, shielded, 9 kHz - 200 MHz
Current Transformer, shielded, 9 kHz - 150 MHz
The SW 9606 Current Clamp was designed to inject RF-currents into conductors or conductor bundles with a maximum diameter of 23 mm. It is compliant to CISPR 16-1-2 or DIN EN 55016-1-2 respectively. The conversion ratio is 1 : 0.125 (I = 0,125 U), i.e. the transfer impedance is 8 Ohm.
The Calibration Jig CA 9608 is used to measure the transducer of current clamps up to 500 MHz acc. to CISPR 16-1-2, MIL-STD-461D or ISO 11452-4. Alternatively the CA 9608 can be used to characterize ferrite materials (e.g. clamping ferrites, toroids, ferrules) or any other passive disturbance supression components as described in CISPR 17.